Friday, March 27, 2015

REVISITING THE HYDRAULIC PRESS

I've had my hydraulic press for several years, and recently the pancake dies from Potter U.S.A. sparked my interest. I ordered two of them, a small feather die for earrings and a larger feather die for bracelets.

Here is the bracelet pancake die to make the feather cuff. I folded a piece of 22 gauge copper sheet lengthwise and textured the top edge with a riveting hammer.



I annealed the piece, opened and flattened it and cut it using the die and hydraulic press.


This is the video using the small feather pancake die that caught my interest.
https://www.youtube.com/watch?v=KaqmLepANks I followed the instructions in the video, and cut each metal piece in half so I would have two sets of earrings. I have yet to drill holes in the earrings and finish wire wrapping.


Photos of the earrings and cuff after texturing and cutting with the die. When I started forming the cuff on a bracelet mandrel, it was too long for a medium-sized wrist. The cuff measured 7 inches. I cut off almost 3/4 inch and it was so much better.


Here are photos of the formed cuff. I'm so pleased with it! It will be finished with liver of sulphur patina later ... once all the other pieces are ready.




Next I cut two more cuffs from 20 gauge copper without fold forming the center. I'm going to solder a copper or sterling silver wire down the center and add feather texturing lines. I'll finish these and show them to you in my next post.

2 comments:

  1. O darn you -thank you for the wonderful information - I have wanted a press so bad and eyeing the potter dies for a few years - the feather especially as I too wanted to make a cuff - great show and tell - now I need to save up and get the press and dies - going to be poor again this year ......

    ReplyDelete
  2. Thanks, Deborah. I love hearing from you ... waiting to see what you'll be working on next.

    ReplyDelete