Here is the bracelet pancake die to make the feather cuff. I folded a piece of 22 gauge copper sheet lengthwise and textured the top edge with a riveting hammer.
I annealed the piece, opened and flattened it and cut it using the die and hydraulic press.
This is the video using the small feather pancake die that caught my interest.
https://www.youtube.com/watch?v=KaqmLepANks I followed the instructions in the video, and cut each metal piece in half so I would have two sets of earrings. I have yet to drill holes in the earrings and finish wire wrapping.
Photos of the earrings and cuff after texturing and cutting with the die. When I started forming the cuff on a bracelet mandrel, it was too long for a medium-sized wrist. The cuff measured 7 inches. I cut off almost 3/4 inch and it was so much better.
Here are photos of the formed cuff. I'm so pleased with it! It will be finished with liver of sulphur patina later ... once all the other pieces are ready.
Next I cut two more cuffs from 20 gauge copper without fold forming the center. I'm going to solder a copper or sterling silver wire down the center and add feather texturing lines. I'll finish these and show them to you in my next post.
